BOOK SPECIFICATION
Format · Extent · Binding · Orientation
210 × 245 mm · 384 pages + 8 pages endpapers · Section-sewn square-spine hardcover · Portrait
COVER
Material · GSM · Board · Printing · Finishing
Material: Black specialty card · GSM: 120 gsm · Board: 2.5 mm greyboard · Printing: PMS 6110 U screen printing · Finishing: Blind debossing on back cover, controlled overhang of 1.5 mm at head and tail and 2 mm at fore-edge
TEXT BLOCK
Paper · GSM · Color · Printing Method
Paper: Rough uncoated white paper · GSM: 140 gsm · Color: CMYK · Printing Method: Sheet-fed offset printing · Binding: Section-sewn with water-based adhesive
ENDPAPERS
Material · GSM · Printing · Attachment
Material: Uncoated paper, FSC Mix 90% · GSM: 140 gsm · Printing: Black with 50/50 gloss-matte mixed varnish · Attachment: Glued endpapers
OTHER COMPONENTS
Dust Jacket · Slipcase · Inserts · Edges
Edges: Three-edge screen printing; head and tail printed black, fore-edge printed black + PMS 6110 U blue with registered artwork alignment to the cover · Spine Reinforcement: Kraft-paper spine tube · Headbands: Black fabric · Sales Sheet: 140 gsm rough uncoated paper, CMYK printing, 200 × 235 mm, placed against the back cover with printed side facing outward · Barcode Label: Self-adhesive label applied after shrink-wrapping · Packaging: Individually shrink-wrapped
PRODUCTION NOTES
Binding Heavy Books
The Challenge
The book is 256 pages and weighs 1,345g. Too much glue makes the spine stiff and prevents the book from opening flat. Too little glue causes structural failure.
Our Solution
Applied a thin, tightly controlled layer of hot-melt adhesive.
This ensures the 256-page text block remains flexible and lays flat while staying secure.
Debossing on Lamination
The Challenge
Debossing over anti-scratch matte lamination can trap air between the film and paper. The heat from the stamp causes this air to expand, creating bubbles around the text.
Our Solution
Ran adhesion tests on the film before the bulk production run.
Operators calibrated the stamping temperature and pressure to ensure the film bonds tightly to the paper, preventing bubbles.
Aligning Complex Finishes
The Challenge
The cover requires both spot gloss UV and registered debossing. Paper often stretches slightly during production, which makes aligning these two finishes difficult.
Our Solution
Kept mechanical guides in the exact same position across all printing and finishing machines.
Used matched, high-precision plates to ensure the spot UV and debossed text align perfectly with the printed graphics.